Date: Tue, 07 Aug 2001 14:43:51 GMT From: "KeithG" <noonenopsaml.com> Subject: Re: Flashing Check Enginer Light? (1991 900S)
Sounds like a bad knock sensor or knock sensor harness. flashes while running means EZK ignition fault http://216.78.173.190/electrical_system_folder/ezkindex.htm the link has lots of EZK information Regards, KeithG "Mark the Milkman" <slycheesenopsamcom> wrote in message news:3b6ff5ae.54654308nopsam.conversent.com... > Hi folks. The other day my check engine light came on (1991 900S). > It flashed 4 times (and then repeated) when the engine was at idle. > Anything above idle the light stayed on steady. Does anyone know what > this means? I read the Bently manual and it doesn't seem to mention > this condition. > > This may or may not be relevant... but the next time I turned on the > car the check engine light was off and it hasn't come on since. I > think it may have been a fluke because of the conditions when the > light first came on: It was a very hot day and I had just started the > car and driven about 3 blocks. I had to stop at a stop sign and then > go up a very steep hill (5-speed tranny). The light came on the > instant I started up the hill. I may have had the AC on too, I'm not > sure. I figure that all this strain (hot day, steep hill, "cold" > engine, AC) could cause a sensor to go out of range for a split second > and cause the light to come on.... maybe. In any case, I'm curious > what the 4 flashes means. > > Thanks for the assitance, > > mark