Date: Sun, 07 Aug 2005 21:17:17 GMT From: Paul Halliday <pjghnospamyonder.co.uk> Subject: Re: Manual Boost Control/Bleed Valve......
in article ugbHe.68853$Pf3.33514nospamnews.blueyonder.co.uk, Al at alistairdorenospamo.com wrote on 31/07/2005 22:20: Hey Al, just thinking around your problem. I can't quite recall some of the details of the troubleshooting of your issue, but here goes ... I just had a basic boost scenario today - turned out to be a bad ground at the APC solenoid valve. If you can use a multimeter, check that no resistance is found between the black wire on the APC solenoid wiring and a good ground point. Voltage can be seen with the key on, but a bad ground will give a basic boost scenario. If so, rewire to ground. I spliced the wire and connected straight to the battery - I'll rewire with new wire to the correct ground point in time ... Honest :) Paul Vart tog v”gen v”gen? SAAB : Nothing on earth comes close
 |
 |
 |
 |
 |
