NG900 & OG93 |
Vintage Models |
Clubs & SOC |
Other Cars |
Books Movies & Music |
Member Photo Galleries |
Member Directory |
What's New |
Photo of the Month |
|93 Bulletin Board|
When I did the job, my autozone had a couple to choose from - I actually returned the first one & got the more extensive set instead. This was a bit of a pain when I had the brakes dismantled.
The best I could do was an adapter that had the correct spacing, but the pins were just barely too big to fit into the holes. By being very careful holding the tool straight & square, they just caught the edges of the holes enough to push & twist.
David K jogged my memory... YES it was the built-in tool at the end of the push screw, without any of the other adapter plates. Still, it looked like the pins were maybe only 0.1mm oversize. Just barely...
->Posting last edited on Tue, 21 Mar 2017 09:21:07.
Posts in this Thread:
Post a Followup
This is a moderated bulletin board - Posting is a privilege, not a right.
Unsolicited commercial postings are not allowed (no Spam). Please, no For Sale or Wanted postings, SERIOUSLY.
Classifieds are to be listed in The Saab Network Classifieds pages.
This is a problem solving forum for over 250,000 Saab owners, so expect to see
problems discussed here even though our cars are generally very reliable. This is not an anything goes
type of forum. Saabnet.com has been a moderated forum since 1988. For usage guidelines, see the
Saabnet.com Mission and Purpose Page. Please remember that you are
not anonymous. Site Contact | Site Donations | Other Sites by SP -
Poverty2Prosperity.org | RandomScreening.com
Your address is: 184.108.40.206 - Using CCBot/2.0 (http://commoncrawl.org/faq/) - Logged.