[General |
Members |
C900 |
9000 |
NG900 & OG93 |
92X |
93 |
95 |
NG95 |
97X |
99 |
Sonett |
Vintage Models |
Performance |
Detail |
Clubs & SOC |
Other Cars |
Books Movies & Music |
Chat |
FAQs |
Gifts |
Photos |
Classifieds |
Polls |
Raffle |
Sponsors]
NG900 & OG93 Bulletin Board 1994-2002 | |
Do you put any type of lube or sealant on the outer edge of the seal before you drive in the main seal or torque converter seal? I have used Hylomar for this in the past with no adverse reaction and I do have experience with seals but never one as critical as this one is labor wise and I am trying to research as much as I can to insure I get it right the first time. I do have a cross beam support, transmission adapter for my long frame jack etc to complete the job tool wise. I will try to find the seal tool you refer to by searching some more. All I have found so far is using the thin plastic of a 2 liter bottle for fashion a seal "ramp" to allow it to go over the crank. Thank you again. Posts in this Thread:
Members can receive an alert when someone posts in this thread.
Post a Followup

The content on this site may not be republished without permission. Copyright © 1988-2012 - The Saab Network - saabnet.com.
This is a moderated bulletin board - Posting is a privilege, not a right.
Unsolicited commercial postings are not allowed (no Spam). Please, no For Sale or Wanted postings, SERIOUSLY.
Classifieds are to be listed in The Saab Network Classifieds pages.
This is a problem solving forum for over 250,000 Saab owners, so expect to see
problems discussed here even though our cars are generally very reliable. This is not an anything goes
type of forum. Saabnet.com has been a moderated forum since 1988. For usage guidelines, see the
Saabnet.com Mission and Purpose Page. Please remember that you are
not anonymous. Site Donations Your address is: 107.21.156.140 - Using CCBot/2.0 - Logged.
|