Date: Sat, 26 Feb 2000 07:16:16 GMT From: herlihyjnopsamnet (John Herlihy) Subject: Re: FAQ: Help needed in replacing clutch in a 88 900
I've always used an old spark plug wire. If the disc is worn out, it has always slid out of the pressure plate for me. I've also had success unbolting the slave and prying and sliding it out, since the worn disc means there is not as much pressure on the assembly. Then it's real easy to get the spark plug wire into the new disc since you can stand on it or put it in a press. some shops can do the whole job in an hour, but it took me 8 the first time I did it. best of luck, John In article <38b5d0a6.651738296nopsam.zip.com.au>, wwwnopsamus-technologies.com wrote: >On Thu, 24 Feb 2000 14:49:42 GMT, just as I was about to see how much duct >tape you REALLY need to stop a gerbil from exploding, ucenopsamgov (Mauricio >Tavares) distracted me by babbling thusly: > >> Ok. I am sold. I need to get one of those spacer rings. >>What are the dimensions? > >OK Hang 5 for a while. When I get time over the weekend, I'll dig up the >hand drawing I did and put up the dimensions here. >