Heat Shield Front Bolt The cylinder with the boot is the shift rod, just feel for the lump that is the bolt and scratch a hole in the insulation. You may need to detatch the plastic wiring sleeve and move it aside. It's a T-25 Torx bolt IIRC. Don't remove the shifter. Last modified: Jun 21, 2007	Heat Shield Rear Bolts Lift up the rear end of the carpet; these bolts sit just aft of the floor console. They are the pair farthest to the right in this photo. Don't forget the two bolts underneath the car! Last modified: Jun 21, 2007	Ignition Key Switch Notice the little button on the side- you align this with the hole (drilled out cap) in the housing, then reach in and press it, and tug the lock cylinder out with a key. Last modified: Jun 21, 2007	Depressing the Lock Cylinder Release Use a drill bit or piece of wire. I used a bicycle spoke. Line up the button with the hole, depress the button, and pull the cylinder out. For those needing more reference, that's the correct wiring for the ignition switch for MY 1992. Last modified: Jun 21, 2007
'87 S Ignition Switch This is the transmission donor car, the best $350 (hoist included) I ever spent! Last modified: Sep 6, 2007

StateOfNine.com

Swedish Dynamics

SaabClub.com

Jak Stoll Performance

M Car Covers

The content on this site may not be republished without permission. Copyright © 1988-2023 - The Saab Network - saabnet.com.
For usage guidelines, see the Mission & Privacy Notice.
[Contact | Site Map | Saabnet.com on Facebook | Saabnet.com on Twitter | Shop Amazon via TSN | Site Donations]