Date: Wed, 22 Sep 1999 08:17:49 -0700 From: "Paul Geller" <pgellernopsamhlink.net> Subject: Re: ACC question
The blink indicates that the command was accepted, but it won't take efect until the car has been turned off for at least ten minutes. The next time you start the car, it should be as you set it... pg cs <xspamcbsnopsamom> wrote in message news:37e7f9ad.33518590nopsam.fuse.net... > Don't know the answer, however, will give you a piece of advice: > don't do it, unless you never want AC. I ran my 9k in econ mode at > almost all times, and after a mere three years, the compressor had to > be replaced because of lack of use. From then on, I've have almost > exclusively run the car in the auto mode. > > > On Mon, 20 Sep 1999 02:53:15 GMT, kr4nopsamnyu.edu (Kalman Rubinson) > wrote: > > >I am trying to reprogram my 9-3 so that the default at ignition is with > >the AC off ("econ"). Manual says to set what you want and then > >simultaneously push "econ" + "fan up." When I do this, the display blinks > >(as it's supposed to) but the AC goes on ("econ" goes off) and the > >programming doesn't take. > > > >Any help or is it a service issue? > > > >Kal > > -- >