The banner above is an advertisment - if it asks you to download software, please ignore.
Site News - 12/12 Make Amazon Pay Saabnet! | 8/11 SimpliSafe Security System Review
Date: Mon, 24 Jun 2002 15:20:09 GMT
From: "notooyou" <peacenopsame.net>
Subject: Re: Keyless entry remote programming?


You are the man... It was a fuse on the alarm unit itself. Works like a champ now. Thanks so much "KeithG" <noonenopsamspring.com> wrote in message news:3D172E43.8060500nopsamspring.com... > Make sure that the fuse is OK on the alarm unit under the seat. Make > sure that the antenna is connected properly to the alarm unit. Does the > unit arm, but just not lock/unlock, or does it just not respond at all? > These alarms are a bit different from your Rover. These are not > 'programmable'. If the light lights, the signal 'should be' sent out > from the remote. If nothing happens, the receiver is not getting it. > > KeithG > > notooyou wrote: > > I had just recently purchased the car and it came with two keychain remotes > > that I assume will unlock and lock vehicle and set / unset the alarm. I am > > not looking for anything tricky to do, just make them work again. I believe > > that they have just come unprogrammed. I have a LandRover Discovery and > > they can unprogram over time due to battery disconection... I was hoping > > there was a procedure to reprogram them.. Thanks again. The remotes are > > black with a sigle light gray button with SAAB Anti-Theft System written to > > the site of the single button. And a red light that comes on when the > > button is pushed. > > Thnaks again, Kyle > > "KeithG" <noonenopsamspring.com> wrote in message > > news:3D1721A4.1030601nopsamspring.com... > > > >>Saw your other post, and you have a CV. The change in the program > >>requires removing the back seat bottom, lifting the alarm unit up and > >>flipping a couple of switches. What do you want to program it to do? > >> > >>KeithG > >> > >>KeithG wrote: > >> > >>>A bit more information is required. Is this a 'SaabGuard' alarm? If so, > >>>the remotes will say 'Saab' on them and they will be black with a single > >>>white button. Is the car a convertible? I will assume that it was a > >>>Saabguard alarm which was installed by the dealer in a 3 dr or 4 dr. I > >>>have one of these in my '92. The Saab installation gives you an alarm > >>>which can be turned on by the remote or by locking the driver door > >>>(passive arming). The actual alarm unit is capable of 'keyless entry' > >>>and also 'light flash', but these were not wired up at the time of > >>>installation. It can be done, but it depends on your level of expertise. > >>>I was able to do it to mine. You must 1) get a door lock motor for the > >>>driver's door 2) wire it up to the lock ECU 3) wire the lock ECU to the > >>>alarm unit to the appropriate pins (this information is detailed in the > >>>Bentley manual for the up to '93 convertibles which used this alarm unit > >>>and had keyless entry from the factory). Light flash requires a DPDT > >>>relay wired to the alarm unit to the appropriate pin (again in the > >>>Bentley) and wiring to the turn signal circuit. > >>> > >>>Good luck, > >>> > >>>KeithG > >>> > >>>notooyou wrote: > >>> > >>> > >>>>Anyone know how to reprogram a keyless entry remote on an older 900? > >>>>I have > >>>>1992 and I would like to program the keyless remotes to work? any > >>> > > Ideas? > > > >>>>Thanks in advance, Kyle > >>>> > >>>> > >>> > > > > >

Return to Main Index
StateOfNine.com
SaabClub.com
Jak Stoll Performance
M Car Covers
Ad Available

The content on this site may not be republished without permission. Copyright © 1988-2024 - The Saab Network - saabnet.com.
For usage guidelines, see the Mission & Privacy Notice.
[Contact | Site Map | Saabnet.com on Facebook | Saabnet.com on Twitter | Shop Amazon via TSN | Site Donations]