Date: Tue, 18 May 2004 13:17:30 +0100 From: MeatballTurbo <carl.robsonnospamcing-czechs.com> Subject: Re: C900 APC Solenoid wiring
In article <2guaslF6o61dU1nospamberlin.de>, grunffnospam.com says... > MeatballTurbo wrote: > > > You mean the 2 pin grey connector that comes out of the solenoid? > > Yes, sorry, that's what I mean. cheers. > > The harness had lost most of it's original insulation, almost all the > > way to the two pin plug., and as far down almost, to the where it joins > > the bundle near the 3 pin connector below the drivers side headlight. > > Mine was the same. Yeah the original slack rubber sleaving was intact arround the bundle, so I had to cut it to get to the wiring which is when I discovered just how bad the problem was. didn't see quite how grotty the insulation was until, I tried to tape it, and the rest just crumbled like candle wax. Ended up removing what I had to, leaving some so I can see which wire is which. Then taping each wire individually right up to the connector, then taping the original rubber cover back in place. > > This the APC Solenoid I'm talking about on top of the radiator with the > > 2 pin plug, not the APC itself, which is nice and cool under the > > backseat. > > I know! just checking. ;) -- The poster formerly known as Skodapilot. http://www.bouncing-czechs.com
 |
 |
 |
 |
 |
