Compressor housing machined for a 19T wheel!
First defuser (flat) area is cut for slight tip height difference, then ID bored and radius cut to correct wheel location!
Last modified: Sep 21, 2011 |
Modified 19T wheel!
After boring this TD04 wheel to the larger TD05 quill size this Super (raised) Back wheel is cut to fit flat back application!
Last modified: Sep 21, 2011 |
7 degree inlet!
Originally has cast in angle but very crude and off center!
Last modified: Sep 21, 2011 |
Minimun safe radial clearance!
This is why TD04's work so well so we apply it to our TD(E)05's!
Last modified: Sep 21, 2011 |
Ported outlet!
This particular one started out somewhat "D" shaped so it really needed some porting!
Last modified: Sep 21, 2011 |
Exhaust inlet port matched!
We blend in crack prone areas and then shot-peen our exhause housings!
Last modified: Sep 21, 2011 |
7 degree included angle cut!
Small radius cut at beginning of 7 degree cut to keep turbulence down!
Last modified: Sep 21, 2011 |
Compressor wheel end clearance!
End clearance is set to just under what radial clearance is machined to!
Last modified: Sep 21, 2011 |
