Date: Tue, 4 May 1999 09:00:58 -0400 From: "Eric Law" <elawnopsamexxx.com> Subject: Re: Boost gauge approximation, please?
If you want accuracy, your dash is the wrong place to look! I've owned several turbos, and the boost gauge calibration varied quite a bit betweent them. My advice: get your hands on a catalog of scientific or industrial supplies, order a nice generic 0-20 or 0-25 PSI gauge that's accurate. Should cost $20.00 tops. Eric Law <Eoin> wrote in message news:3728a902.20483130nopsam1.ibm.net... > I received my 9-3's ECU back from Abbott this morning along > with a new waste gate and instructions. I am instructed to fine-tune > the boost to 1.2 bar at 3500 rpm in 3rd gear. My calculator says 1.2 > bar is 17.4 psi, sooo, I need to know about where that is on a 9-3 > (same as NG900?) boost gauge. The bump where I live has 1 store with a > boost gauge, and it only goes to 10 psi. All assistance appreciated. > > --Eoin > > Addressable as Bullwinkle in the > commercial domain of mostlysunny
 |
 |
 |
 |
 |
