Date: Mon, 07 Feb 2000 17:41:58 GMT From: malcolm532nopsameja.com Subject: Re: Bonnet Rattle on '85 900 T
<Snip> Eva, I assume that it's just wear and tear that has caused this, not an accident. Anyway first I would adjust the rear sliders, at the back of the bonnet and then the rubber bump stops at the front to lift the bonnet. Unfortunately there isnt much back and forwards adjustment except at the front where the hinges attach to the bonnet panel it's self. If you start messing about here be careful as it's a bugger to get right again! Mark the original position with a permanent marker BEFORE you undo the bolts. It's all abit trial and error I'm afraid as I found out when trying to get the bonnet to sit properly on my 1991 16v. Hope this helps Malc Scotland Sent via Deja.com http://www.deja.com/ Before you buy.