The banner above is an advertisment - if it asks you to download software, please ignore.
Site News - 3/26 M Car Covers (by State of Nine) | 12/12 Make Amazon Pay Saabnet!
Date: Wed, 06 Feb 2002 17:18:56 +0000
From: danny <dannynopsamia-esprezzo.com>
Subject: Re: ventilation fan speed (inbetween settings)


Johannes H Andersen wrote: > Bryan wrote: > > > > danny <dannynopsamia-esprezzo.com> wrote in message news:<3C5F09EC.BFCEE2EDnopsamia-esprezzo.com>... > > > Bryan wrote: > > > > > > > I have a 9000cs 93 model with standard aircon (not climate control). > > > > What frustrates me is fan settings 1 & 2 are quite low (fine in winter > > > > but useless in Summer), while switching to setting 3 gives adequate > > > > summer ventilation but hurricane-like noise. Essentially the fan > > > > speed gap between setings 2 & 3 is too large. Does anyone know if it > > > > is possible to either crank up setting 2, or reduce setting 3 so that > > > > an acceptable level of airflow can be achieved without all the noise? > > > > I expect that it is just rheostat that the dial operates. Has anyone > > > > tried this or does anyone know how to remove the fan speed dial to see > > > > what's behind? > > > > thanks > > > > Bryan > > > > > > My 1990/91 9000CD has a four speed fan, not sure how it differs from yours > > > (mine has aircon, no climate control). There isn't a rheostat - in the > > > bulkhead (easily accessed from the engine bay under the plastic tray) is > > > the fan motor with a plug in unit that contains resistance wires for each > > > speed (no resistance for top speed), together with the thermal fuse. It > > > would be possible to change the length of a resistance wire and thus alter > > > the fan speed, if you could work out how much to chop off! For your > > > convenience I've added a page to my site below (www.gaggia-espresso.com) - > > > follow the Saab 9000 link for pictures of the resistor pack location. > > > This may not apply to your vehicle as some 9000's have the fan control in > > > an awkward location (in the dash, I believe?). > > > > Thanks Danny, > > Mine also has 4 speeds. It looks easier than I anticipated. I can > > just buy / make extra resistance wires and replace with the existing > > number 2 & 3 resistors till I get a better combination. > > Thanks again > > Bryan > > The resistors consume considerable power and are dependent on cooling > from the airflow. make sure the resistors are sufficiently rated. > > Johannes That's part of my theory of why the thermal fuses are prone to blowing. I think that the resistor pack gets too hot before positive airflow has been established by the fan. Since renewing the thermal fuse when it went on mine, I now always turn the fan straight to full, then back to the desired setting, in the belief this will get the air moving before using the resistors. -- Regards, Danny http://www.gaggia-espresso.com (a purely hobby site) http://www.dannyscoffee.com (UK advert for my mobile espresso service) swap Z for above characters in email address to reply

Return to Main Index
StateOfNine.com
SaabClub.com
Jak Stoll Performance
M Car Covers
Ad Available

The content on this site may not be republished without permission. Copyright © 1988-2024 - The Saab Network - saabnet.com.
For usage guidelines, see the Mission & Privacy Notice.
[Contact | Site Map | Saabnet.com on Facebook | Saabnet.com on Twitter | Shop Amazon via TSN | Site Donations]