Date: Wed, 19 Mar 2003 09:31:11 +0000 From: Grunff <grunffnopsam.com> Subject: Re: Classic 900 Dash Replacement
Paul Halliday wrote: > Have I just not made a good enough seal when re-fitting the metal ring, or > did other models have an open connector in number 7? The vac pipe cluster > seemed to go on with less resistance than it came off the original. Looks > like I'll have to remove the dash again and retro-fit the vent control. > Grrrr. Hmmm...I really can't remember. I'm not too tempted to remove one of my dashes to check either ;-) I'd pull it out again and check the seal. I'll have a look in my Bentley when I get home, see if there's a photo/diagram of the back of the vac switch. > Also, only the top two (of three) and bottom two (of three) electrical > connections on this controller were connected. Is this normal? Yup, that's normal. -- Grunff