Date: Sat, 30 Apr 2005 23:14:17 +0100 From: Pooh Bear <rabbitsfriendsandrelationsnospamail.com> Subject: Re: 9000 Loom uprate - ideas and comments?
Dexter J wrote: > Salutations: > > I think I am about to start pulling my loom and relays to check them over > for fit, finish , conductivity and function. Anyone have a really good > source for a complete schematic for a 1993 9000 Aero? > > I would very much like to do this once if possible. While there, I would > like to install better connectors and heavier wire where appropriate. Any > leads on a good general source for both? > > Finally - there are several loom end point connectors that are specific to > a given electrical device. ie the Safety Valve. Any thoughts on casting > better (more robust and perhaps water proof) connectors in these cases? Is > it time to break out my old Lionel epoxy modeling kit? Many of the connectors are specific to the item they connect to. The Bosch air mass sensor comes to mind for some reason. If you do want to replace connectors where you can - bear in mind that auto connectors are designed for an aggressive enveronment. Only military / aerospace types are likely to outperform them. Graahm
 |
 |
 |
 |
 |
