Date: 25 Jul 2006 07:13:02 -0700 From: "yaofeng" <yaofengchennospaml.com> Subject: Re: Another round of trolls
> Have you done the CV + axle? Do you want to remove the cv from my 9000 > (the bnospamd) so I can change the boot? The damn thing is glued in > place :-D > You may want to consider replacing the CV joint boot from the tripod bearing side. You can do it from the CV joint side by opening the snap ring and knocking the CV joint out of the shaft at the same time. I found it far easier to remove the tripod bearing to remove both the inner drive boot and the CV joint boot by sliding them out of the drive shaft. You need a gear puller to remove the tripod bearing. If you don't have one Autozone lets you borrow one for free. Either way it is a messy job.