The banner above is an advertisment - if it asks you to download software, please ignore.
Site News - 3/26 M Car Covers (by State of Nine) | 12/12 Make Amazon Pay Saabnet!


Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Photo Gallery for MikeinVT


| 9-5 Wagon 3rd Brake Light Replacement

This album contains 5 photos and 0 albums.


Step 1
Open the hatch and remove the cover over the light. It's held on with plastic clips, gently pull it towards you and it pops right off.
Last modified: Oct 29, 2010

Step 2
Gather your tools, 10mm wrench/socket/nut driver, small flat screwdriver, and a beer. Remove the 3 nuts holding the light in and disconect the wireing. Mine was wrapped in tape.
Last modified: Oct 29, 2010

Step 3
Close the hatch and lift out the light.
Last modified: Oct 29, 2010

Step 4
Remove the 3 screws (philips) holding the black cover on the LED strip, and then replace it after dropping in the new strip. It only fits on one way, keep in mind everything is plastic so don't over tighten.
Last modified: Oct 29, 2010

Step 5
Replace the light in the hatch. I found it easier to see where the wires go by standing on the bumper. Tighten the 3 nuts evenly a little bit at a time. USE YOUR FINGERS ONLY until the light is snug. Reconect the wires and snap the cover back on. Done
Last modified: Oct 29, 2010


StateOfNine.com
SaabClub.com
Jak Stoll Performance
M Car Covers
Ad Available

The content on this site may not be republished without permission. Copyright © 1988-2024 - The Saab Network - saabnet.com.
For usage guidelines, see the Mission & Privacy Notice.
[Contact | Site Map | Saabnet.com on Facebook | Saabnet.com on Twitter | Shop Amazon via TSN | Site Donations]