NG900 & OG93 |
Vintage Models |
Clubs & SOC |
Other Cars |
Books Movies & Music |
Member Photo Galleries |
Member Directory |
*Buddy Registry |
*Mileage Registry |
What's New |
Photo of the Month |
|C900 Bulletin Board|
1979-1993 & 94 Conv
So I went to start my 91 900T yesterday and the ignition broke in the run position, the cylinder now moved freely without any engagement. I have a spare entire ignition assembly and last night I drilled out the side of it to remove the key cylinder. I was planning to put the cylinder from the car into this assembly to maintain the same key, then triacs the while assembly. The more I read, the more involved this gets, I just want to make sure I'm on the right track. I'm planing together into this tomorrow, any wisdom would be appreciated. -Josh
Posts in this Thread:
Post a Followup
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
This is a moderated bulletin board - Posting is a privilege, not a right.
Unsolicited commercial postings are not allowed (no Spam). Please, no For Sale or Wanted postings, SERIOUSLY.
Classifieds are to be listed in The Saab Network Classifieds pages.
This is a problem solving forum for over 250,000 Saab owners, so expect to see
problems discussed here even though our cars are generally very reliable. This is not an anything goes
type of forum. Saabnet.com has been a moderated forum since 1988. For usage guidelines, see the
Saabnet.com Mission and Purpose Page. Please remember that you are
not anonymous. Site Contact | Site Donations | Other Sites by SP -
Your address is: 220.127.116.11 - Using CCBot/2.0 (http://commoncrawl.org/faq/) - Logged.