[Subscribe to Daily Digest] |
[Main Performance Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Re: DoI have to bend wastegate arm ormake a bracket for6cm Posted by 900 Aero [Email] (#425) [Profile/Gallery] (more from 900 Aero) on Sun, 26 Dec 2010 15:23:14 In Reply to: DoI have to bend wastegate arm ormake a bracket for6cm, Bill H, Sun, 26 Dec 2010 13:06:39 Members do not see ads below this line. - Help Keep This Site Online - Signup |
The waste gate valve linkage in the 6CM2 housing is 1" further away from the inlet flange than the linkage in 5CM2 housing is so unless there's room to aim your compressor outlet down and forward rather than down and back like yours is a 1" dogleg in the waste gate actuator rod should work! I stock longer waste gate actuator ends (eyes) as of course the bending effectively shortens the rod. Fabricating something to relocate your waste gate actuator to line up wouldn't work because then the rod would run into your compressor housing's outlet. As far as grinding off the dowel in the exhaust housing just pull it out with pliers or vice grips if necessary rather than grinding it of. Actually the last one I removed came out just by grabbing it with my fingernails.
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.