Passenger Side
Last modified: Aug 17, 2008 |
Brake Lines
These were shot, and shooting fluid into the rear seat area.
Last modified: Aug 17, 2008 |
Front
Much cleaner after POR 15 and spray undercoating.....ready for insulation
Last modified: Aug 17, 2008 |
Front Patches
Using Nascar grade steel to patch the floors, it's not a daily driver, so no welding, but good marine glue and sealant.
Last modified: Aug 17, 2008 |
Drivers Sides
Lots more scraping ahead plus removal of the brake lines.
Last modified: Aug 17, 2008 |
Rear Area Repaired
Much cleaner, rust repaired with POR 15 and undercoating, new brake lines in.......
Last modified: Aug 17, 2008 |
Passenger Front
This was the beginning, that heat mat was saturated.....ah, that's where the power steering fluid went!
Last modified: Aug 17, 2008 |
Ready for etching
Last modified: Aug 17, 2008 |
Ready for undercoating.....
Last modified: Aug 17, 2008 |
Trunk Corner
The trunk floor was replaced some years ago, but a minor hole resurfaced....may as well fix to pass inspection
Last modified: Aug 17, 2008 |
Thermal Pad
I added some thermal padding in case we ever make it back north....saw this in a similar 900 on Flickr
Last modified: Aug 17, 2008 |
Back together
Almost back together......waiting on the seats to go back in. Rug doctored the carpet while it was out.
Last modified: Aug 17, 2008 |
