 |
 |
 |
 |
 |
Date: Fri, 18 May 2001 17:56:56 +0100 From: danny <dannynopsamAMGaggia-espresso.com> Subject: Re: fan resistors
Johannes H Andersen wrote: > It just happened today, now I'm no longer so smug. The electric fan inside > my 93 9000 CSE will only work on step 4! I have read here that you can > replace some resistors in the switch, but how do I get inside the panel? > > Johannes If the '93 is the same as the '90 then the resistor pack is located in the bulkhead (engine bay side) and plugs into the side of the blower motor housing. remove the plug, and buy a new thermistor? These have to be crimped on, as they are heat sensitive. I did mine last year for a cost of a couple of pounds. You will be able to see if any of the resistor wires have gone - if not you just need the thermistor. This is usual when all but high speed has gone. -- Regards, Danny http://www.gaggia-espresso.com Remove "nospam" from email address to reply
|
|
|
|
|