| FRONT |
|
| |
| 1. Drive the car onto a car lift, but do not lift it up yet. |
| 2. Unload the suspension wishbones on both sides using tool
8393209 positioned under the upper wishbone. (A couple of wood blocks
can also be used - ed) |
| 3. Raise the car to half-height and remove the front wheels. |
| 4. Raise the car to full height. |
| |
| |
| |
| Points 5-11 only apply to cars without pre-drilled holes.
|
|
| |
|
| |
| 5. Position the drilling template on the reinforcing beam
(Z-beam). Hold the template against the the suspension swivel clamp, and
along the weld. |
| 6. Mark and drill the two 3 mm dia. holes. |
| |
| |
| |
| |
 |
| |
| |
| 7. Enlarge the holes to 22 mm dia. with a hole saw. These
holes are necessary in order to drill fixing holes in the upper side of
the beam. |
| |
| |
Printable
PDF version available: 
