1979-1993 & 94 Conv [Subscribe to Daily Digest] |
[Main C900 Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Re: Can't install clutch slave cylinder Posted by vvack0matic [Email] (#1443) [Profile/Gallery] (more from vvack0matic) on Mon, 26 Nov 2012 04:26:43 In Reply to: Can't install clutch slave cylinder, Bill S., Sun, 25 Nov 2012 20:34:46 Members do not see ads below this line. - Help Keep This Site Online - Signup |
Make sure the throw-out bearing on the slave is pushed all the way on, it can protrude just a little creating more unnecessary mass. press the bejesus on it and get it way down the slave shaft. After that's done put mount the pressure plate on one dowel pin then spin the pressure plate out ward getting as much of the plate as u can away from the flywheel that will enable the slave to be fitted into the pressure plate center hole, then spin the pressure plate back in (using the one dowel pin as a pivot) once the plate is spun in with the slave set the slave in its home and it will create a little room for the pressure plate to be mounted on the last two dowel pins. Did I mention to have the clutch disk in before mounting the 1st dowel pin.
posted by 184.77.37...
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.