1985-1998 [Subscribe to Daily Digest] |
[Main 9000 Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
You need to loosen the bolt under the AC compressor Posted by Rod [Email] (#3128) [Profile/Gallery] (more from Rod) on Thu, 28 Jul 2005 08:58:11 In Reply to: oxygen sensor wiring harness... stuck??, rhale, Wed, 27 Jul 2005 13:43:09 Members do not see ads below this line. - Help Keep This Site Online - Signup |
It's difficult, but possible, to get at it without removing the compressor. I just did it a few weeks ago but I didn't need to pull the connector out since I was replacing the original sensor with a universal sensor and keeping the original connector in place. This meant I only had to loosen it enough to pull the wiring through. If you need to get the connector out too then you i suspect you may actually need to remove the AC compressor to remove the bolt completely.
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.