1985-1998 [Subscribe to Daily Digest] |
[Main 9000 Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Re: pulling ABS codes on a 97 Aero Posted by skibumm100 [Email] (#3255) [Profile/Gallery] (more from skibumm100) on Wed, 21 Aug 2013 09:08:28 In Reply to: Re: pulling ABS codes on a 97 Aero, sam96CS [Profile/Gallery] , Tue, 20 Aug 2013 20:52:50 Members do not see ads below this line. - Help Keep This Site Online - Signup |
Neither my Aero nor my CSE show a "low brake fluid" light at key on/engine off. I looked at my manual this morning and it describes the "low brake fluid" light and where it is......neither work. I'm not sure I want to dig into the instrument cluster for a bulb job. The brake fluid on my Aero was at the "min" mark, the CSE is full. The Aero must have actually been lower as I just changed the rear brake pads and rotors a couple weeks ago and had to retract the caliper pistons. That only brought it up to the "min" mark. That could be a bad thing as it is a manual trans car so the clutch may have been sucking air before the brake job. The clutch acted fine before the brake job and only started acting up the other day. When I pushed in the clutch pedal to shift, it pushed back and almost felt like an ABS event, except on the clutch pedal. After that my release bearing is making a whiring noise. May be somewhat unnrelated, but it's an awfully odd coincidence.
posted by 63.236.2...
_______________________________________ long-time listener, first-time caller Saab glutton for punishment
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.