1950-1966 [Subscribe to Daily Digest] |
 | [Main Vintage Models Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Re: Need advice on vacuum lines after 2bbl weber Posted by StephenB [Email]  (#2415) [Profile/Gallery]
(more from StephenB) on Tue, 1 May 2012 02:44:18
In Reply to: Need advice on vacuum lines after 2bbl weber, BAAB   [Profile/Gallery]
, Wed, 25 Apr 2012 21:19:56
Members do not see ads below this line. - Help Keep This Site Online - Signup
|
Ahoy, yep had th esame problem. If yo ublock it the Oil filler cao will blow off. Actually put a strap on th ecap and tie it to a plug lead.
What I did re breather is to get some small bore 3/8" (I think) irigation pipe and elbows I then made up a run that turned tight from the breather hole and ran it around to join into the line that feeds into your air filter - "T"'d into the fuel canister breather line. To fit it into the valve cover I cut the barb off and built it up with Duct Tape then put a small pilot hole into the valve cover and screwed it into place. So far its worked without a hitch.
My air filter is a "Ram-Flow" with a single breather hole. I have since ditched the fuel breather and just run the breather straight in to th eair filter.
Are you also replacing the camshaft? If so you may want to get a lower temperature thermostat off Jack and MArk Ashcraft (160 degrees) as mine suffered bad overheating issues.
posted by 119.40.111...
, Wed, 25 Apr 2012 21:19:56, Tue, 1 May 2012 02:44:18 <-- Viewing This Message
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
 |
 |
 |
 |
 |
