[Subscribe to Daily Digest] |
 | [Main General Bulletin Board | BBFAQ |
Prev by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Here's what TMD Friction (Textar) says ... Posted by RS [Email]  (#15)  [Profile/Gallery]
(more from RS) on Wed, 29 Jul 2015 12:09:32
In Reply to: Bedding Textar brake pads -- procedure?, bender  [Profile/Gallery]
, Tue, 28 Jul 2015 11:56:41
Members do not see ads below this line. - Help Keep This Site Online - Signup
|
New brake pads have to be bedded in upon installation. Correct bedding guarantees that new brake pads and new rotors work flawlessly together. In order to function optimally, organic brake pads must develop friction coal on its surface. This friction coat develops at a temperature of about 280 degrees C (537F). It is very important that this temperature is reached continuously and slowly. This process results that the temperature not only is penetrating the surface of the brake discs and pads, but also evenly through the whole disc and pad material. This is essential when using new brake discs, since the disc often shows signs of strains (due to the casting process and fast cooling) in the materials. A steady and careful warming and cooling process guarantees a good release of both materials.
The bedding in/break in procedure should be done as follows:
• Drive at approx. 35 mph (60 kmh) for about 500 yards (solid front discs) to 800 yards (vented front discs) while slightly dragging the brakes (i.e. light brake pedal pressure). This process allows the brake temperature to slowly and evenly build up to 300°C (572°F).
• Now, if possible, drive about 2200 yards maintaining the same speed without braking. This will allow the pads and discs to cool down evenly. After this cool-down, perform a normal brake application from 35 mph to 0. No panic stops!
• Now, the friction surface has evenly developed friction coat, the pads have bonded with the disc surface, and tensions in the disc materials will have disappeared.
• Only trained master mechanics should perform this procedure before delivering the vehicle to its owner. Do not expect your customer to properly finish your brake job!
• This bedding process is only suitable for the front axle - not the rear. This is due to the brake force distribution of front and rear axles. In order to reach 300°C (527°F) on the rear pads you would have to drive several miles with dragging brakes.
However, in that time the front brakes will be glowing red, overheating and thus destroying the front brakes.
• Final note – don’t forget to clean hubs and check the wheel bearings. Also, the brake fluid should be replaced at least every 2 years.
http://www.tmdfriction-aftermarket.com/worldpac/downloads/brake_pad_bedding_in_procedure.pdf
, Tue, 28 Jul 2015 11:56:41, Wed, 29 Jul 2015 12:09:32 <-- Viewing This Message, Wed, 29 Jul 2015 14:52:12
, Tue, 28 Jul 2015 12:28:16, Wed, 29 Jul 2015 07:11:01, Wed, 29 Jul 2015 11:24:56
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
 |
 |
 |
 |
 |
