|
|
|
Rust under carpet - brake line related
Last modified: Apr 28, 2012 |
what is this? looks like something rubber falling out of the floor pan! passenger side front.
Last modified: Jul 4, 2013 |
aftermarket cat (iirc, bosal) doesn't fit too well in the heat shield. Had to lower it to prevent rattles!
Last modified: Jul 4, 2013 |
what is the circular impression in the body? is it rubber? same as the bit hanging in the other photo. drivers side.
Last modified: Jul 4, 2013 |
|
|
|
passenger side. original. pretty good for 20 years in the salt belt. rust proofing helps!
Last modified: Jul 4, 2013 |
drivers side. pretty good for 20 years in the saltbelt! rustrpoofing works!
Last modified: Jul 4, 2013 |
rust in a weld under passenger side rear seat
Last modified: Jul 4, 2013 |
Bosal vs Magnaflow. Note the magnaflow is quite a bit narrower. The bosal was almost impossible to align to avoid rattling against the heat shield!
Last modified: Jul 24, 2013 |
|
|
|
Magnaflow cat installed in heat shield. about 3/4" on either side. No rattles. Easy to align!
Last modified: Jul 24, 2013 |
This is a 205 series 16" tire on super aeros on a sedan
Last modified: Oct 21, 2015 |
super aeros
Last modified: Oct 21, 2015 |
turn stalk disassembled
turn stalk disassembled - drill for 2-56 3/8" flat head screws + countersink cover
Last modified: Jun 15, 2020 |
|
|
|
turn stalk complete
turn stalk complete - looks pretty much like the factory made it this way
Last modified: Jun 15, 2020 |
newexahust
New exhaust - rust proofing everywhere!
Last modified: Jun 15, 2020 |
Rust Check vs missed spot!
Rust Check vs not: can see the bracket for the mount, never sprayed previously, is rusting + the rest is fine!
Last modified: Jun 15, 2020 |
Rust Check sills
They drill holes, spray inside the body, then plug.
Last modified: Jun 15, 2020 |
|
|
|
Rustcheck hood
Oily film everywhere is the downside. Upside, paint still in awesome shape after decades.
Last modified: Jun 15, 2020 |
Rustcheck door
Again, plugs top and bottom, they spray inside the door. Saab has a plug there in the middle for the same purpose, but I guess they can access more better with the 2 holes.
Last modified: Jun 15, 2020 |
Jigsaw vs O2 sensor
sawed from inside out to remove it (crushing with vice grips helped). Absolutely hate removing these, as with all the corrosion from road salt, moisture, and thermal cycling, they are nearly impossible to break loose!
Last modified: Jun 15, 2020 |
Sedan rust, trunk
Moisture under the rubber seal caused rust. Removed the seal, prepped and coated in POR15. This part is hidden, so I just reinstalled the seal without top coating the POR. The metal under the seal had never been oil sprayed.
Last modified: Jun 15, 2020 |
|
|
|
Tan headliner
Tan headliner to match interior. 1993.
Last modified: Jun 15, 2020 |
trunk inside latch
black arrow points to where the lever is that you pull (I think down) to release. Green arrow points to roughly where the license plate light hole is...
Last modified: Jun 15, 2020 |
Elusive hole in B pillar
There was a tab that fit in the rectangular hole of the B pillar trim + then snapped into the square hole on the B pillar. upon removal, it pulled out of the trim + fell down the hole into the B pillar! every time! not sure how to affix this now?!? only h
Last modified: Jun 15, 2020 |
Another view of B pillar mounting
It's held on at the top but loose + sloppy at the bottom. Need a fastener for the bottom mounting point! any suggestions??
Last modified: Jun 15, 2020 |
