[Subscribe to Daily Digest] |
[Main General Bulletin Board | BBFAQ |
Prev by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Cause of engine oil sludge..... Posted by REM in Seattle [Email] (#4) [Profile/Gallery] (more from REM in Seattle) on Mon, 10 Dec 2001 09:37:58 In Reply to: Engine sludge?, Nick [Profile/Gallery] , Mon, 10 Dec 2001 03:40:48 Members do not see ads below this line. - Help Keep This Site Online - Signup |
Engine OIl Sludge (from http://www.tpub.com/engine3/en32-44.htm)
"Gummy or carbonaceous material that accumulates in lubricating oil is called SLUDGE. Most engine lubricating oils have some natural ability for preventing conditions that may cause sludge to form and for carrying sludge that does form in a finely suspended state until it is removed by filtering equipment. Chemicals are added to some oils to improve the ability of the oils to prevent the formation of sludge. The formation of sludge is greatly reduced when the lubricating oil has the proper stability. STABILITY is defined as the ability of the oil to resist oxidation and deterioration for long periods. Proper stability is essential for a strong oil film to be maintained throughout the normal temperature ranges of an operating engine. A strong oil film provides the required oiliness, or film strength, to form a seal between the piston and the cylinder wall. With the oil seal in place, burned fuel and exhaust gases cannot get by the piston rings to form sludge.
Various factors tend to cause sludge to form in an engine. Carbon from the combustion chambers or from the evaporation of oil on a hot surface, such as the underside of a piston, will cause sludge to form. Gummy, partially burned fuel, which gets past the piston rings, or an emul-sion of lubricating oil and water, which may enter the lubricating oil system, will also tend to form sludge.
Sludge in the lubricating oil system of an engine is harmful for several reasons. In addition to carbon and gummy material, sludge may contain abrasive ingredients, such as dust from the atmosphere; rust as a result of water condensation in the engine; and metallic particles resulting from wear of engine parts. Sludge in engine lubricating oil causes premature wear of parts and eventual breakdown of the engine. Sludge may clog the oil pump screen or collect at the end of the oil passage leading to a bearing, thereby preventing sufficient oil from reaching the parts to be lubricated. Sludge may coat the in-side of the crankcase, act as an insulator, and blanket the heat inside the engine. This condition will cause the oil temperature to increase and induce oxidation. Sludge may accumulate on the underside of the pistons and prevent proper heat transfer, thereby raising piston temperatures. Sludge in lubricating oil also contributes to sticking piston rings, a condition that will affect the ability of the rings to seal the cylinder."
Now that we have defined engine oil "sludge", why does it happen in new engines? Probably because owners don't read the fine print of the ownes manual. Most new car owners manuals recommended oil and filter changes every 7,500 or 10,000 miles in 'normal driving conditions'. Usually there is a disclaimer in the owners manual that states frequent stop and go driving, high speed driving, excessive idling, excess hot or cold weather, short trips, and basically everything but BUT 20-50 mile open freeway driving constitutes 'severe driving conditions'. "Severe driving conditions" require oil and filter changes every 3,000 to 5,000 miles.
So the vast majority of drivers fall into the 'severe driving conditions' catagory. I drive 10 miles each way to work in city driving. I personally use Mobil 1 synthtic oil and change my oil and filter every 5,000 miles. Obviously synthetic oil can last for 10,000 miles or more, but given my driving habits I am concerned about fuel contamination of the oil and condensation in the oil crankcase. So I change the oil more frequently beacause of my driving style.
posted by 208.49.24...
_______________________________________ REM in Seattle Current: 2013 Volvo XC60 R-Design, Rebel Blue, 3.0L 6-cyl turbo, Automatic 2024 MINI Cooper S Convertible, 2.0L 4-cyl turbo, 6-speed manual Former: 2005 Saab 9-3 Aero Convertible, Steel Gray metallic, 2.0L 4-cyl turbo, 5-speed 1998 Saab 900SET 5-door, Silver, 2.0L 4-cyl turbo, Automatic 1991 Alfa Romeo Spider convertible, Alfa Red, 2.0L 4-cyl, 5-speed 1984 Saab 900T 3-door, Red, 2.0L 4-cyl turbo, 5-speed
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.