1950-1966 [Subscribe to Daily Digest] |
Hi Kansas thanks for answering.
Let me try to clear up my last message.
The pressure plate is over 1/4" away from the flywheel when the bolts first need a wrench to turn them. It does tighten all the way down like it should. The clutch disk only goes in one way from what I have seen. The disk is flat on one side with another small raised metal section in the middle of the other side. This part with the raised section I put towards the pressure plate and incidentally the transmission.
When the pressure plate is torqued at 15 lbs to the flywheel, the surface that the throwout bearing should contact (the part that sits over the 3 levers that actuate the clutch) does not stick out. Instead it is flush with the rest of the surface of the pressure plate. I was thinking that this should stick out a little ways and when you push on the pedal it would go in about that far.
When I shimmed the slave cylinder, I put washers between the back of the cylinder and the tab on the transmission it rests against, the part where the bolt goes through. This pushed it further and further towards the engine. I shimmed it almost an inch before it began to release the clutch. This was the point where you could hear the fork start to hit the pressure plate.
How can you tell if the clutch fork is bent? It looks ok. The top hole that the throwout bearig sits in is a little bit sloppy but it is equal all the way around, not elongated. It is perhaps a 32nd of an inch to large on all sides. The other thing that baffles me is that the clutch was working before I pulled the engine. The only thing that was done beside the new clutch part was to suface the flywheel. I checked the step hight of the flywheel and it was just a hair over 16mm.
I can post photos if that would help. How do I post them here if I don't have a site to post them on?
Thanks, Drew
posted by 68.189.129...
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.