1985-1998 [Subscribe to Daily Digest] |
Yes. The few occasions I did this I had the whole drive shaft on the bench and start from the inner end.
Remove the snap ring at the end of the drive shaft.
Pull the tripod bearing using the gear puller.
Remove the inner boot.
Remove CV joint boot.
Clean the CV joint and repack grease.
Slip on the new CV joint boot..and so on and so forth.
posted by 96.242.17...
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
![]() |
![]() |
![]() |
![]() |
![]() |
